MONTHLY PMCS

Change engine oil and filter — use correct viscosity per current temperature range; dispose of properly

Service air cleaner — clean or replace filter element per restriction indicator reading

Drain and inspect fuel filter/water separator — replace element if contaminated or at service interval

Check coolant concentration — must be 50/50 antifreeze/water; test with refractometer

Inspect and clean battery — remove corrosion from terminals and tray; apply protective coating

Load test battery — must maintain 9.6V under load for 15 seconds at 0°F rating

Inspect all air brake lines, fittings, and chambers — no corrosion, cracks, or leaks

Check wheel bearing adjustment on all 6 wheels — repack if required

Inspect and lubricate door hinges, cab latches, and hood hinges — apply light oil or grease

Check transfer case fluid — inspect level and condition; change per service schedule

Check differential fluid levels — front and rear axles; inspect seals and drain plugs

Inspect cargo bed tie-down rings and side board hardware — replace any cracked or missing hardware